HP LaserJet 1022nw Printer - Manual (Page 26)

Verification fails at end of installation
Possible problem: You are using advanced forms of encryption, such as dynamic
encryption, WPA, or WPA-PSK, the encryption methods must be entered through the
embedded Web server. For more information, see
Embedded Web server .
In dynamic encryption, each device has a different key and all keys change frequently.
Dynamic encryption is much harder for an intruder to circumvent, since the keys are likely to
change before the intruder can reverse engineer them.
Possible problem: Your SSID or WEP key might be incorrectly set. Complete the following
procedure to set the SSID or WEP key:
1. Print a configuration page. To print a configuration page, when the printer is in the
Ready state, press and hold the G
O
button until the Ready light starts blinking. For more
information, see Configuration page .
2. Make sure the network SSID and WEP key on the device and the wireless network
match.
3. If one or both are incorrect, enter either the URL or device IP address from the
configuration page into the Address field on your Web browser. The printer EWS Home
page appears.
4. Select the Networking tab.
5. Click the Wireless option.
6. Enter the correct values in the appropriate sections (Network Name (SSID) and
Encryption).
7. Click Apply.
Possible problem: Your network uses multiple WEP keys, and you have chosen the wrong
key for transmitting.
1. Print a configuration page. To print a configuration page, when the printer is in the
Ready state, press and hold the G
O
button until the Ready light starts blinking. For more
information, see Configuration page .
2. Enter either the URL or device IP address from the configuration page into the Address
field on your Web browser. The EWS Home page appears, showing the printer device
information.
3. Click the Networking tab.
4. Click the Wireless option.
5. In the Encryption section, select the Static (WEP) option.
6. Under Static (WEP), enter the WEP keys used by your network. In static encryption, the
same key is used for all devices on the network and the key remains the same for long
periods of time.
7. Choose the key to be used to encrypt transmitted data. (The installer defaults to WEP
Key 1.)
8. Click Apply.
9. If the installation has terminated, restart the printer software CD-ROM.
Possible problem: You are using advanced authentication protocols that are not supported
by the installation software, such as LEAP, PEAP, EAP-MD5, EAP-TLS, or EAP-TTLS.
20 Chapter 3 Problem solving ENWW