HP LaserJet 1022nw Printer - Manual (Page 35)

Regulatory information
USA Federal Communications Commission (FCC) compliance
CAUTION Based on Section 15.21 of the FCC rules, changes or modifications to the operation of this
product without the expressed approval by Hewlett-Packard Company may invalidate its
authorized use.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against interference when the equipment is operated in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if
it is not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
● Reorient or relocate the receiving antenna.
● Increase separation between the equipment and receiver.
● Connect equipment into an outlet on a circuit different from that to which the receiver is
connected.
● Consult your dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Exposure to radio frequency radiation
CAUTION The radiated output power of this device is far below the FCC radio frequency exposure
limits. Nevertheless, the device shall be used in such a manner that the potential for human
contact during normal operation is minimized.
In order to avoid the possibility of exceeding the FCC radio frequency exposure limits,
human proximity to the antenna shall not be less than 20 cm (8 inches) during normal
operation.
ENWW USA Federal Communications Commission (FCC) compliance 29