HP Designjet 111 Printer series - Manual (Page 10)

The roll feed
The roll feed is supplied with the HP Designjet 111 Roll printer. It allows the printer to print on a roll of
paper up to 610 mm (24 in) wide. It includes an automatic cutter.
The roll is loaded from the rear of the printer and must be fed into the rear feed slot.
Once a print job to a roll has finished, the printer will automatically cut the roll. However, the cutter
can be disabled from the printer driver. The printer also cuts the roll if you press the
OK key.
NOTE: If a roll of paper is loaded and you want to print to a cut sheet, you must first unload the roll.
The HP Jetdirect print server
The HP Jetdirect print server is a network card that can be installed in the printer. It allows the printer
to be connected to a network, allowing the printer to be accessed from different computers on the
network.
To install the card, first turn off and unplug the printer. Then remove the blank plate from the rear left
of the printer, and insert the card in its place.
The card connects to the network via the socket on its end-plate.
4 Chapter 1 Introduction ENWW
Introduction