HP Designjet 111 Printer series User Manual
Page 18
You may find that sharing your directly connected printer with other users will slow down your
computer unacceptably.
TIP:
The best way to share the printer over a network is to connect the printer not to any computer,
but to the network.
Change the IP address of the HP Jetdirect print server
You may need to do this if you are moving the printer from one LAN subnet to another, and need to
change the IP address because of a conflict.
NOTE:
If you are using the DHCP protocol, you do not need this procedure, because the addresses
are assigned automatically.
NOTE:
This procedure will not work if the print server is not correctly configured, either because of
an error or because it is a brand new card.
The correct procedure depends on your operating system.
First, print the configuration pages of the HP Jetdirect print server, in the following way.
1.
Press and hold down the
Power
key (the bottom key on the front panel).
2.
Press the
OK
key (the upper right key on the front panel) four times while the
Power
key is
pressed.
3.
Release the
Power
key. The printer prints the configuration pages.
Look for the TCP/IP area in the printed configuration pages, which contains the current IP address of
the HP Jetdirect print server, in the format 'nnn.nnn.nnn.nnn' (where each nnn is a number between 0
and 255).
Windows
If you are using a Jetdirect card that already has an IP address, skip to step
If you are using a Jetdirect card that has an IP address of 192.0.0.192, begin at step 1.
1.
At your computer, click Start > Control Panel > Network Connections.
2.
Right-click Local Area Connection and select Properties.
3.
Select Internet Protocol (TCP/IP) and click Properties.
4.
Select Use the following IP address.
5.
Change the IP address to 192.0.0.193.
6.
Change the subnet mask to 255.255.255.0. Leave the other fields empty. Click OK to close the
menus.
7.
Open a Web browser and type the IP address of your printer.
8.
Click the Networking button.
9.
Select TCP/IP from the menu at the top of the page and then select Manual from the IP
Configuration Method pull-down list.
10.
Enter the IP address and subnet mask in the appropriate fields. Click the Apply button.
11.
If your Jetdirect card previously had an IP address of 192.0.0.192, open the Control Panel's
Network Connections and change the TCP/IP configuration back to its original configuration.
12
Chapter 2 Connection and software installation
ENWW
Co
nnect & install