HP Designjet 111 Printer series - Manual (Page 46)

4. Remove the rear path by pressing the buttons on each of its sides and pulling it straight out. If
you don't pull it straight out, you may damage the paper sensor.
Removing the rear path gives access to the inside of the printer from the rear.
5. Pull out any paper that may be stuck inside or that is accessible from the rear.
6. Replace the rear path and make sure it fits securely.
7. Turn on the printer.
8. After clearing a paper jam, you are recommended to align the printheads to avoid print-quality
problems. To align the printheads, start HP Designjet System Maintenance and select Align
printheads; you do not need an Internet connection to do this.
Roll paper
1. Turn off the printer.
2. Remove the front paper tray. This will allow you to see inside the printer through a slot in the
front. Release and remove any trapped paper that is accessible.
3. Lift the top cover, being careful not to damage or disturb any of the tubes or other internal parts
of the printer. If there is any paper trapped in the wheels inside the printer, release and remove
the paper.
4. Remove the rear path by pressing the buttons on each of its sides and pulling it straight out. If
you don't pull it straight out, you may damage the paper sensor. If there is any paper trapped in
the rollers inside the printer, release and remove the paper.
5. Once the paper jam has been cleared, replace any parts of the printer (paper tray, top cover,
rear path) that you have removed or opened, making sure they fit securely.
6. Turn on the printer.
40 Chapter 11 General printer issues ENWW
Gen
eral issues