HP Designjet 111 Printer series - Manual (Page 16)

5. In the list of printers that appears, select the entry that uses the connection type USB, and click
Continue.
6. The following screen displays information about your printer's installation, where the name of the
printer can be modified. Make any changes you wish to make, and click Continue.
7. Your printer is now connected. In the Printer Queue Created screen, click Quit to exit, or Create
New Queue if you want to connect another printer.
8. When the HP Printer Setup Assistant has finished, you can remove the CD from the CD drive.
If the printer driver is already installed, the HP Printer Setup Assistant can be run at any time from the
CD.
Connect to a network using Bonjour (Mac OS)
Before you begin, check that the following statements are true.
● The printer is set up and turned on.
● The Ethernet hub or router is on and functioning properly.
● All computers on the network are on and connected to the network.
● The printer is connected to the Ethernet network.
To connect your printer, follow these steps.
1. Print your HP Designjet printer information pages by pressing the OK key (upper right key on the
front panel) four times while holding down the Power key, then releasing the Power key. Note
the hardware address on the first page.
2. Install the Mac OS printer driver: see Install the Mac OS printer driver on page 9 .
3. When the driver has been installed, the HP Printer Setup Assistant starts automatically, to set up
a connection to your printer. Follow the instructions on your screen.
4. When you reach the Select Printer screen, look for your printer's hardware address (which you
noted in step 1) in the Printer Name column.
● If you find the right printer name, scroll sideways to see the Connection Type column, and
check that it shows Bonjour/Rendezvous. Then highlight that line. Otherwise, continue
searching further down the list.
● If you cannot find your printer name with a Bonjour/Rendezvous connection type, check
the box My printer is not in the list.
Click Continue.
5. Continue following the instructions on the screen. When you reach the Printer Queue Created
screen, click Quit to exit, or Create New Queue if you want to connect another printer to the
network.
6. When the HP Printer Setup Assistant has finished, you can remove the CD from the CD drive.
If the printer driver is already installed, the HP Printer Setup Assistant can be run at any time from the
CD.
10 Chapter 2 Connection and software installation ENWW
Co
nnect & install