The input tray won’t fit, Gen eral issues – HP Designjet 111 Printer series User Manual

Page 48

Advertising
background image

Both the Paper Status and the Paper Jam icons are flashing; the paper has
stalled.

See

Paper is jammed in the printer on page 39

.

Both the Roll and the Paper Jam icons are flashing; the roll must be unloaded
manually.

See

Unload a roll of paper on page 21

.

One or more of the Printhead Status icons are flashing; the printheads need
replacing.

See

Replace printheads on page 27

.

The Use System Maintenance icon is on; there is a hardware error. Run the
System Maintenance tool for the printer.

See

HP Designjet System Maintenance on page 34

.

The Paper misaligned icon is flashing. The paper is misaligned and must be
reloaded to print.

See

Paper handling on page 15

.

All the Ink Cartridge Status icons are flashing; there is an ink cartridge problem.

See

All ink cartridge icons in the front panel are flashing on page 38

.

One of the Ink Cartridge icons is flashing; the corresponding cartridge is empty.
The last block of the corresponding icon flashes if a cartridge is low on ink.

See

Replace ink cartridges on page 26

.

The input tray won’t fit

Try inserting and removing the tray two or three times. Normally this should resolve the problem. If it
doesn't, see below.

Inside the slot where the tray goes there are two spring-loaded latches. If they are not in the correct
position, the tray won't fit properly.

Make sure that both latches are forward. If necessary, pull them towards you.

42

Chapter 11 General printer issues

ENWW

Gen

eral issues

Advertising