Sata or sas hard drive option – HP ProLiant ML350 G5 Server User Manual
Page 39
Hardware options installation 39
NOTE:
Depending on model purchased, the server may look slightly different than shown.
SATA or SAS hard drive option
IMPORTANT:
When installing a x3/x1 SAS cable in a SFF system, HP recommends that the x3
part of the x3/x1 cable be linked to the SAS hard drive backplane connector that corresponds
to hard drive slots 1 to 4. In this setup, hard drive slot 1 will not be available, but since hard
drive slots 2 to 4 will be connected, one continuous volume can be created. All drive slots will
be available in LFF systems.
To install the component:
1.
Open the bezel (tower model) ("
Open or remove the tower bezel
2.
Remove the existing hard drive blank (on page
NOTE:
Depending on model purchased, the server may look slightly different than shown.