HP ProLiant ML350 G6 Server - Manual (Page 88)

Hardware options installation 88
In addition to the supplied items, you may need:
• T-10 Torx screwdriver
• T-15 Torx screwdriver
To convert a tower server to a rack server:
1. Power down the server (on page 24 ).
2. Disconnect all rear panel cabling (" Rear panel components " on page 9 ).
3. Remove the tower bezel (" Open or remove the tower bezel " on page 25 ).
4. Remove the feet.
5. Remove both tower configuration panels:
a. Using the T-10 Torx screwdriver, remove the front panel screws.
b. Unhook the tower configuration panels from the chassis.