HP Officejet Pro 8500 - Manual (Page 139)

To set up the device with DSL
1. Obtain a DSL filter from your DSL provider.
2. Using the phone cord supplied in the box with the device, connect one end to the
open port on the DSL filter, and then connect the other end to the port labeled 1-
LINE on the back of the device.
NOTE: You might need to connect the supplied phone cord to the adapter
provided for your country/region.
If you do not use the supplied cord to connect from the DSL filter to the device,
you might not be able to fax successfully. This special phone cord is different
from the phone cords you might already have in your home or office.
As only one phone cord is supplied, you might need to obtain additional phone
cords for this setup.
3. Connect an additional phone cord from the DSL filter to the telephone wall jack.
4. Run a fax test.
If you encounter problems setting up the device with optional equipment, contact your
local service provider or vendor for further assistance.
Case C: Set up the device with a PBX phone system or an ISDN line
If you are using either a PBX phone system or an ISDN converter/terminal adapter,
make sure you do the following:
•
If you are using either a PBX or an ISDN converter/terminal adaptor, connect the
device to the port that is designated for fax and phone use. Also, make sure that
the terminal adapter is set to the correct switch type for your country/region, if
possible.
NOTE: Some ISDN systems allow you to configure the ports for specific
phone equipment. For example, you might have assigned one port for
telephone and Group 3 fax and another port for multiple purposes. If you have
problems when connected to the fax/phone port of your ISDN converter, try
using the port designated for multiple purposes; it might be labeled multi-
combi or something similar.
• If you are using a PBX phone system, set the call waiting tone to "off."
NOTE: Many digital PBX systems include a call-waiting tone that is set to ON
by default. The call waiting tone will interfere with any fax transmission, and
you will not be able to send or receive faxes with the device. Refer to the
documentation that came with your PBX phone system for instructions on how
to turn off the call-waiting tone.
Set up faxing for the device 135