HP LaserJet M1005 Multifunction Printer series - Manual (Page 109)

The device does not appear in the Macintosh Print Center after the driver is selected.
Cause Solution
This problem is caused by either a software or a hardware
component. Software problem solving
● Check that your Macintosh supports USB.
● Verify that your Macintosh operating system is Mac OS X V10.3
or Mac OS X V10.4.
● Ensure that your Macintosh has the appropriate USB software
from Apple.
Hardware problem solving
● Check that the device is turned on.
● Verify that the USB cable is connected correctly.
● Check that you are using the appropriate high-speed USB cable.
● Ensure that you do not have too many USB devices drawing
power from the chain. Disconnect all of the devices from the
chain, and connect the cable directly to the USB port on the host
computer.
● Check to see if more than two nonpowered USB hubs are
connected in a row on the chain. Disconnect all of the devices
from the chain and connect the cable directly to the USB port on
the host computer.
NOTE: The iMac keyboard is a nonpowered USB hub.
ENWW Solving common Macintosh problems 99