HP LaserJet M1005 Multifunction Printer series - Manual (Page 75)

Managing supplies
Checking supplies status
If the supplies levels are low, you can order supplies through your local HP dealer, by telephone, or
online. See
Accessories and ordering information on page 101 for part numbers. See www.hp.com/go/
ljsupplies to order online.
Storing supplies
Follow these guidelines for storing print cartridges:
● Do not remove the print cartridge from its package until you are ready to use it.
CAUTION: To prevent damage, do not expose the print cartridge to light for more than a few
minutes.
● See Environmental specifications on page 112 for operating and storage temperature ranges.
● Store the supply in a horizontal position.
● Store the supply in a dark, dry location away from heat and magnetic sources.
Replacing and recycling supplies
To install a new HP print cartridge, follow the instructions that are included in the box that contains the
new supply, or see the getting started guide.
To recycle supplies, place the used supply in the box in which the new supply arrived. Use the enclosed
return label to send the used supply to HP for recycling. For complete information, see the recycling
guide that is included with each new HP supply item. See
HP LaserJet printing supplies on page 118
for more information about HP's recycling program.
Redistribute toner
If faded or light areas appear on the printed page, you might be able to temporarily improve print quality
by redistributing the toner.
1. Remove the print cartridge from the printer.
2. To redistribute the toner, gently rock the print cartridge from front to back.
CAUTION: If toner gets on your clothing, wipe it off with a dry cloth and wash the clothing in cold
water. Hot water sets toner into the fabric.
3. Reinsert the print cartridge into the printer, and close the print cartridge door. If the print is still light
or unacceptable, install a new print cartridge.
HP policy on non-HP supplies
Hewlett-Packard Company cannot recommend the use of non-HP supplies, either new or
remanufactured. Because they are not HP products, HP cannot influence their design or control their
quality. Service or repairs required as a result of using a non-HP supply will not be covered under the
warranty.
ENWW Managing supplies 65