HP Color LaserJet CM4730 Multifunction Printer series - Manual (Page 251)

Control panel message Description Recommended action
Novel login required Novell authentication has been enabled for
this destination. Enter Novell network credentials to access
the requested feature.
Order <color> Cartridge The identified print cartridge is nearing the
end of its useful life. The MFP is ready and
will continue for the estimated number of
pages indicated. Estimated pages remaining
is based upon the historical page coverage of
this MFP.
Printing will continue until a supply needs to
be replaced.
Order a replacement print cartridge.
Order Fuser Kit The fuser is near end of life. The MFP is ready
and will continue for the estimated number of
pages indicated. Printing will continue until a
supply needs to be replaced. Order a replacement fuser kit.
Order staple cartridge The staple cartridge needs to be replaced. 1. Replace the staple cartridge.
Order Supplies One or more supplies needs to be replaced. 1. Replace the supply.
Order Transfer Kit The transfer kit is near end of life. Printing can
continue. Order a replacement transfer kit.
Output bin <x> full The specified output bin is full and printing
cannot continue. Empty the bin to continue printing.
Output paper path open The paper path between the MFP and the
output device is open and must be closed
before printing can continue. 1. If you have a 3-bin mailbox installed,
make sure the jam-access door is
closed.
2. If you have a stapler/stacker installed,
make sure the staple cartridge is
snapped into position and that the
staple-cartridge door is closed.
Password or name is incorrect. Please
enter correct login. The user name or password was typed
incorrectly. Retype the user name and password.
Performing Color Band Test The color-band test is being performed. No action is necessary.
PIN is incorrect. Please re-enter PIN. The PIN was typed incorrectly. Retype the PIN.
Please turn device off and install hard
disk. The requested job requires a hard disk, but
the MFP does not have a hard disk installed. Turn the MFP off and install a hard disk.
Printing CMYK Samples The CMYK-samples page is being
generated. The device will return to the ready
state upon completion of the page No action is necessary.
Printing Color Usage Log The color-usage-log page is being
generated. The printer will return to the ready
state upon completion of the page. No action is necessary.
Printing Demo Page This message displays while the demo page
is being generated. The device will return to
the ready state upon completion of the page. No action is necessary.
Printing Diagnostics Page This message displays while the diagnostics
page is being generated. The device will
return to the ready state upon completion of
the page. No action is necessary.
Table 16-1 Control-panel messages (continued)
ENWW Control-panel messages 235