HP Color LaserJet CM4730 Multifunction Printer series User Manual
Page 353
Advertising
6.
Align the groove on the side of the flash memory card with the notches in the connector and push
it in the slot until it is fully seated.
CAUTION
Do not insert the flash memory card at an angle.
NOTE
The first flash memory slot marked "Firmware Slot" is reserved for firmware only.
Slots 2 and 3 should be used for all other solutions.
7.
Align the formatter board in the tracks at the top and bottom of the slot, and then slide the board
back into the MFP.
NOTE
To prevent damage to the formatter board, ensure the formatter board is aligned in
the tracks.
ENWW
Install memory and fonts 337
Advertising