HP Surestore 64 Director Switch - Manual (Page 123)

Configure Operating Mode 107
Config
uring the
Di
re
ctor
Configure Operating Mode
Use the procedure in this section to select the director’s operating mode and
interoperability mode.
Introduction
Typically, S/390 mode is used when attaching an IBM S/390 Parallel Enterprise or z/Series
server to the director.
Note Hewlett Packard does not support this mode.
Select Open Systems mode for all other Fibre Channel environments. When you select this
mode, you can select an interoperability mode.
Procedure
To configure the interoperability mode for the director, use the following steps:
The director must be offline before you change operating modes.
1. If the director is not offline:
a. Select Set Online State from the Maintenance menu.
The Set Online State dialog box displays as shown in Figure 35.
Figure 35 Set Online State Dialog Box (Currently Online)
b. Click the Set Offline button to set the director offline.