HP Hitachi Dynamic Link Manager Software - Manual (Page 293)

6. Command Reference
269
#
• When a summary is displayed by specifying the
-path -c
parameter and there
are 11 or more characters in the summary string, any characters after the 9th
character are not displayed, and ellipsis (
...
) are displayed instead.
• For command devices,
-CM
is added to the end of the emulation type of the storage
system (for example,
DF600F-CM
).
(4) Parameters Used When Displaying LU Information
When displaying LU information, if the
-item
parameter,
-c
parameter, or the
-c
-item
parameter is specified at the same time as the
-lu
parameter, you can add and
display items and display a summary of LU information. This section describes each
parameter and the LU information and displayed items.
Parameters to display LU information:
-lu
When neither the
-c
nor
-item
parameter is specified with the
-lu
parameter,
the information about the LU recognized by HDLM is displayed. The sorting key
is
iLU
and its configuration information is displayed for each LU.
Note that:
• For the Thunder 9500V series, Lightning 9900 series, Lightning 9900V
series, Hitachi USP, Hitachi AMS2000/AMS/WMS/SMS series, Universal
Storage Platform V/VM, and Virtual Storage Platform LU information is
displayed for each storage system.
• For the EMC DMX series and EMC CX series, LU information is displayed
for each vendor ID.
• For the HP EVA series, LU information is displayed for each
vendor_ID_product_ID.
By using the sub-parameter,
-hdev
or
-pathid
, you can filter the LU
information to be displayed. If you do not specify
-hdev
or
-pathid
, the
information about all LUs recognized by HDLM is displayed. For details on the
content of each displayed item, see Table 6-18: Displayed LU Information.
The sub-parameters are:
-hdev
host-device-name
Displays information only for the paths accessing the specified host device.
Specify a drive letter to indicate the desired host device. You cannot specify
the host device unless a drive letter has been assigned. The host-device-name
string is case sensitive. If the command ends with the KAPL01064-W or
KAPL01013-E message, follow the recommended action in the message.