Snmp/network management settings – HP NetStorage 6000 User Manual
Page 31
Configuring Your System and Network
Alert Settings
3-8
SNMP/Network Management Settings
If you are using a Simple Network Management Protocol (SNMP) tool,
you can define the names of the servers to receive notification in case of a
failure.
To define the servers to receive notification:
1
Using the NetStorage web interface, click the Configuration tab, then
select Alert Settings > SNMP/Network Management.
By default, the Community String field is set to
public
and the Trap
Destination fields are blank.
2
In the Trap Destination fields, enter the IP addresses or names of the
servers you want the system to notify (up to five).
3
Enter a value in the Volume Capacity Threshold field to receive a
warning message if your volume gets to a certain capacity. By default,
the field is set to 95 percent
4
Click either:
•
Send SNMP Test Trap to send a cold boot test trap to the destination
addresses and save your changes.
•
Apply to only save your settings.
Note
The information on this screen is optional. Blank fields do not affect the
functionality of the device.