HP StorageWorks 2.140 Director Switch - Manual (Page 179)

Director Element Manager user guide 179
1. Select Configure > Preferred Path.
The Configure Preferred Paths dialog box is displayed as shown in Figure 83 .
Figure 83 Configure Preferred Paths dialog box
The Configure Preferred Paths dialog box provides the configuration for a single switch’s
preferred path. The dialog box lists the following information:
• Source Port—Lists the source port of the preferred path.
• Source Addr (FICON Management Style only)—This column lists the source address of the
preferred path.
• Exit Port—Lists the exit port of the preferred path.
• Exit Addr (FICON Management Style only)—Lists the exit address of the preferred path.
• Destination Domain ID—Lists the domain ID of the destination switch or director. The range
of the destination domain ID number is 1 through 31.
NOTE: Some columns may only display when the FICON Management Style feature has
been installed.
2. Take the appropriate action:
• If a warning message is displayed notifying you that the switch or director has not been
configured for insistent domain ID:
• Close the dialog box and select Configure > Operating Parameters > Switch
Parameters.
• Select the Insistent check box in the Configure Switch Parameters dialog box.
• Return to the Configure Preferred Paths dialog box and continue to
step 3 .
• If there is no warning message, continue with step 3 .
3. Click Add to configure a new preferred path.
The Add Preferred Path dialog box is displayed as shown in Figure 84 .
Figure 84 Add Preferred Path dialog box