Cleaning the glass cooktop (cont.) maintenance, Warning, Caution – GE JS750DFWW User Manual

Page 25

Advertising
background image

49-80690-3

25

Damage from Sugary Spills and Melted Plastic

Special care should be taken when removing hot substances to avoid permanent damage of the glass surface.
Sugary spillovers (such as jellies, fudge, candy, syrups) or melted plastics can cause pitting of the surface of your
cooktop (not covered by the warranty) unless the spill is removed while still hot. Special care should be taken when
removing hot substances.
%HVXUHWRXVHDQHZVKDUSUD]RUVFUDSHU
Do not use a dull or nicked blade.

1. Turn off all surface units. Remove hot pans.
2. Wearing an oven mitt:


 D8VHDVLQJOHHGJHUD]RUEODGHVFUDSHU &(5$0$

%5<7(

®

Ceramic Cooktop Scraper) to move the

spill to a cool area on the cooktop.

b.

Remove the spill with paper towels.

3. Any remaining spillover should be left until the surface

of the cooktop has cooled.

4. Don’t use the surface units again until all of the

residue has been completely removed.

NOTE: If pitting or indentation in the glass surface has
already occurred, the cooktop glass will have to be
replaced. In this case, service will be necessary.

Cooktop Seal (on some models)

To clean the cooktop seal around the edges of the glass,
lay a wet cloth on it for a few minutes, then wipe clean
with nonabrasive cleaners.

CARE AND CLE

ANING:

Cleaning the Glass Cooktop / Maintenance

Cleaning the Glass Cooktop (Cont.)

Maintenance

SHOCK OR BURN HAZARD:%HIRUHUHSODFLQJRYHQOLJKWEXOEGLVFRQQHFWWKHHOHFWULFDO
power to the range at the main fuse or circuit breaker panel. Failure to do so may result
in electric shock or burn.

WARNING

BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot
glass with bare hands or a damp cloth can cause burns.

CAUTION

G9 Bulb

Socket

Tab

Glass cover

Receptacle

(on some models)

Oven Light Replacement (on some models)

To remove:
 7XUQWKHJODVVFRYHUFRXQWHUFORFNZLVHWXUQXQWLO

the tabs of the glass cover clear the grooves of the
socket. Wearing latex gloves may offer a better grip.

 8VLQJJORYHVRUDGU\FORWKUHPRYHWKHEXOEE\

pulling it straight out.

To replace:
 8VHDQHZYROWKDORJHQEXOEQRWWRH[FHHG

50 watts. Replace the bulb with the same type of bulb
WKDWZDVUHPRYHG%HVXUHWKHUHSODFHPHQWEXOELV
rated 120 volts or 130 volts (NOT 12 volts).

 8VLQJJORYHVRUDGU\FORWKUHPRYHWKHEXOEIURPLWV

packaging. Do not touch the bulb with bare fingers.
Oil from skin will damage the bulb and shorten its life.

3. Push the bulb straight into the receptacle all the way.
4. Place the tabs of the glass cover into the grooves of

WKHVRFNHW7XUQWKHJODVVFRYHUFORFNZLVHWXUQ

For improved lighting inside the oven, clean the glass

cover frequently using a wet cloth. This should be
done when the oven is completely cool.

5. Reconnect electrical power to the oven.

Use

gloves

or cloth

Receptacle

Advertising