GE JD750SFSS User Manual

Installation instructions, 30" electric drop-in ranges, Important

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Installation
Instructions

30" Electric

Drop-In Ranges

ryi Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.GEAppliances.com.

' In Canada, call 1.800.551.3344 or visit www.GEAppliances.ca.

BEFORE YOU BEGIN

Read these instructions carefully and completely.

.IMPORTANT

— Save these instructions for

local inspector's use.

.IMPORTANT

— Observe all governing

codes and ordinances.

. Note to Installer - Be sure to leave these

instructions with the consumer.

Note to Consumer - Keep these instructions for

future reference.

Skill level - Installation of this appliance requires a
qualified installer or electrician.

Proper installation is the responsibility of the installer.

Product failure due to improper installation is NOT

covered under the warranty.

ATTENTION INSTALLER:

All electric drop-in ranges must be hard wired (direct wired) into on

opprovedjunction box. A plug and receptacle is NOT permitted on these products.

FOR YOUR SAFETY

A WARNING

Before beginning the installation, switch power off at the service panel and lock the

service disconnecting means to prevent power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a prominent warning device, such os a tog, to the service
panel.

A WARNING

The information in this manual must be followed to minimize the risk of fire, electric shock,

or to prevent property damage, personal injury or loss of life.

A.

A WARNING

Tip-Over Hazard

A child or adult can tip the range and be killed.

Verify the anti-tip bracket has been properly installed
and engaged.

Ensure the anti-tip bracket is re-engaged when the range
is moved.

Do not operate the range without the anti-tip bracket in

place and engaged.

Failure to follow these instructions can result in death or
serious burns to children or adults.

MATERIALS YOU MAY NEED

TOOLS YOU MAY NEED

Junction Box

1/8" Drill Bit and Electric Drill

Phillips Screwdriver

Wire Nuts

Level

Flathead Screwdriver

Strain Relief Clamp for 1/2" Conduit

Tape Measure

1/4" Nut Driver

Straight edge or Square

Hammer

Hand or Saber Saw

Safety Glasses

Pencil

31-10829-1

07-12 GE

Advertising
This manual is related to the following products: