Dishwasher installation, Step 24: replace toekick, Step 25: literature – GE PDT750SSFSS User Manual

Page 13

Advertising
background image

Dishwasher Installation

STEP 24: REPLACE TOEKICK

• Place toekick against the pre-toekick (on some models) and

legs of the dishwasher.

Figure AH

Attachment

Screws

Toekick

• Align the toekick with the bottom edge and make sure it is

DJDLQVWWKHÀRRU

• Insert and tighten the 2 toekick attachment screws. The

WRHNLFNVKRXOGVWD\LQFRQWDFWZLWKWKHÀRRU

• When reinstalling the toe kick on models with a sound barrier,

ensure that the bottom edge of the rubberized flap is flush
with the floor. Any excess material should be tucked up
behind the outer door. Do not allow excess rubberized flap to
lay on the floor. If any excess is not tucked completely behind
the outer door, it will bunch up between the door and toe kick
and impede proper opening and closing of the door. This will
be noticeable because the door will not stay fully open and
will spring up.

Tip: Reduce sound from under the dishwasher. Make sure
toekick is against floor.

STEP 25: LITERATURE

• Be sure to leave complete literature package, these

Installation Instructions and product samples and/or coupons
with the consumer.

13

Sound

Barrier

STEP 23: POSITION INSULATION, PRE-

TOEKICK, AND SOUND BARRIER

(on some models)

Skip this step if the sound insulation package is not supplied
with the dishwasher.
• Locate the sound insulation package and pre-toekick

packages inside the dishwasher.

• Stand the parts upright as shown.

• Locate the control box.

• Push insulation block portion under the dishwasher until it is

beneath the control box.

• Push the panel portion up to the front of the block.

• Tuck the sides of the front panel behind the toekick

attachment screw holes.

• Open door all the way, if the door doesn’t stay fully open,

adjust the insulation panel.

• On models so equipped, position pre-toekick over the

insulation. Align the screw holes with the screw holes on the
legs of the dishwasher.

Toekick

Panel

(On some

models.)

Insulation

Block

(On some

models.)

Dishwasher

Door

Pre-

Toekick

(On some

models.)

Sound barrier

(On some

models. Part is

already attached

to door.)

Push the sides of the insulation behind

the toekick attachment screw holes

Figure AF

Control Box

Figure AG

Figure AH

• On models so equipped, remove the masking tape from the

sound barrier and door front. Position the sound barrier over
the insulation.

Advertising