GE JV347HWW - Manual (Page 11)

11
FOR 3-1-4s ;s RECTANGULAR
'8&7('',6&+$5*(,167$//$7,216
ONLY:
Attach H[KDXVWDGDSWRUGDPSHU over the appropriate
knockout opening (for vertical or horizontal, depending
on installation) with two exhaust adaptor screws. Make
sure damper SLYRW is nearest to WRSEDFNHGJH of hood.
Remove WDSH from damper flap.
Tape
Top/back edge
Exhaust adaptor/damper
(vertical discharge position)
Pivot
(depending on
installation)
FOR 7s ROUND VERTICAL DUCTED
',6&+$5*(,167$//$7,21621/<
Bend up the duct alignment ears in preparation for
later attachment of the 7s duct.

9
Installation Instructions
Exhaust adaptor/damper
(horizontal discharge position)
Attachment ear tabs
)255(&(66('%27720&$%,1(76
ONLY

Wood shims
(minimum thickness 3/8s
‡,IWKHFDELQHWVKDYHIURQWVLGHRUEDFNWULPPDNH
2 wood shims a minimum of 3/8s thick and cut to fit
the width of the inner recessed cabinet bottom. Attach
them to the cabinet bottom recess on both sides. See
Step 11 for marking locations.