GE ZGU484NGPSS - Manual (Page 16)

16
4 ** CHANGE GRILL ORIFICE
(cont.)
A. Remove the grill cover,
grates and grate frame. Lift
the radiant baffle straight
up and off.
B. Remove the 2 hex head
screws from the top of
the igniter.
• Remove one screw from
each side of the burner
surround.
• Lift out the surround.
C. Carefully push the
igniter aside and under
the burner. Do not pull
or pinch the wire.
Remove 4 burner
attachment screws, 2
at the front and 2 at the
back. Slide the burner
assembly toward the
back and out of the gas
inlet.
D. Use a 1/2” deep well
socket to remove and
replace the orifice .
Reverse these steps to
re-assemble the grill. Be
sure to place the unused
orifice in the holder for
possible future use.
E. Adjust Grill “LO” Setting
• Make certain gas and electricity to unit are turned off.
• Turn the grill knob to LO and remove the knob by
pulling straight off.
• Insert a small flat-blade screwdriver into the hole in the
center of the valve stem to engage set screw.
• To convert the LO setting from natural gas to LP, turn
the screw clockwise until it stops
(about 3/4 turn). It may be necessary
to grasp the exterior of the valve
stem with a pair of pliers to prevent
the valve stem from rotating as the
set screw is adjusted.
• To convert the LO setting from the LP
to natural gas setting, turn the screw
counterclockwise about 3/4 turn.
4 ** CHANGE GRILL ORIFICE
(if present)
Locate the 1–1/2” long Grill orifice.
Select for your gas type. LP ³ .047, NAT ³ .067
Installation Instructions for Gas Conversion
Burner
Surround
Igniter
Burner
Assembly
3 CHANGE BURNER ORIFICES (cont.)
IMPORTANT: Find your model number below. Read
each orifice label to identify and install them in the
exact locations shown.
A. Return the unused orifices to the holder. Reattach
the holder and the instruction sheet with screw in
the original storage location.
B. Replace the burner heads, caps and top grates. On
range models, replace rear vent trim.
ZDP304 SIMMER ORIFICES
A 34SL or 51SN orifice
will be used on all burners.
ZDP364, ZDP366, ZDP484, ZDP486
SIMMER
ORIFICES
MAIN
ORIFICES
A 34SL or 51SN orifice will
be used on all burners.
Use 108XL or
190XN orifices
for all burners.
ZDP304 MAIN ORIFICES
A 84XL or
126HXN orifice
will be used
on these three
burners.
Use a 108XL
or 190XN orifice
for the right
front burner.
Remove
2 hex
head
screws
Surround
Screws
Front of Range