GE ZET938SMSS - Manual (Page 17)

17
a. With oven installed, take the bottom trim
and center it on the bottom front edge of
the cabinet opening.
b. Using the trim
as a template,
mark the center
of each slot
(two total) where
the mounting holes
will be drilled.
c. Remove the trim.
d. Drill pilot holes into
the center of each
template mark.
Installation Instructions
Installing the Metal
Bottom Trim
IMPORTANT: If this unit is ever
removed from the cabinet or the oven
is ever pulled out for service, the trim
must be removed first or damage to
the trim will occur.
C4 Preparing for the Bottom
Trim Installation
C3
Side
Trim
Side
Trim
Metal Lower Trim
* Remove
Lower Trim
Before
Pre-drilling
Mounting
Holes
For 27 ″ (68.6 cm)
models with Lower
Trim in Position,
Mark (2) Mounting
Hole Locations
here
a. Place the bottom metal trim centered over
the pre-drilled mounting holes. Tape the
edges of the trim down to maintain the
alignment.
b. Using two trim screws provided, secure
the bottom trim to the bottom edge of the
cabinet.
For 30 ″ (76.2 cm)
models with
Lower Trim in
Position, Mark
(2) Mounting
Hole Locations
here
Trim Screw Locations for
27
″ (68.6 cm) models with
Lower Trim
Trim Screw Locations for
30
″ (76.2 cm) models with
Lower Trim
*