GE ZET938SMSS - Manual (Page 4)

4
Installation Instructions
Cutout for 27
″
(68.6 cm)
Single Built-In
Ovens only
For JKS10, JKP30, JKP70, PK916, ZEK938 models only.
A
Cabinet Width 27” (68.6 cm)
Recommended
Cutout Location
from Floor
32 1/2” (82.6 cm)
Cutout Depth 23 1/2”
(59.7 cm) Min.
Cutout Width 25” (63.5 cm) Min.
25 1/4” (64.1 cm) Max.
Cutout Height 27 5/8” (70.2 cm) Min.
28 1/8” (71.4 cm) Max.
If the cabinet does not have a solid bottom,
two braces or runners must be installed
level with the bottom of the cutout to
support the weight of the oven. For
single ovens, the runners and braces
must support 150 lbs (68 Kg).
18"
27"
24"
2" x 4" or
Equivalent
Runners
24”
(61 cm)
2” x 4” (5 cm x 10 cm) or
equivalent runners level
with bottom of cutout
NOTE: If marks, blemishes or the
cutout opening are visible above the
installed oven, it may be necessary to
add wood shims under the runners and
front trim until the marks or opening
are covered.
These ovens are not approved for
stackable installations.
NOTE: If the cabinet does not
have a front frame and the sides
are less than 3/4” (1.9 cm) thick,
shim both sides equally to
establish the cutout width.
5” (12.7 cm)
Max. from the
left or right
side
Junction Box
Location
Allow a minimum
of 20” (50.8 cm) for
clearance to adjacent
corners, drawers, walls,
etc. when door is open
Allow 1” (2.5 cm)
for overlap of
oven over side
edges of cutout
2” x 4”
(5 cm x 10 cm)
or equivalent
runners level
with bottom
of cutout
Cabinet
Width
27” (68.6 cm)
Cutout
Height
27 5/8”
(70.2 cm) Min.
28 1/8”
(71.4 cm) Max.
22” (55.9 cm)
Min. above
base rail
Recommended
cutout location
from floor 32 1/2”
(82.6 cm)
20” (50.8 cm)
Alternate Junction
Box Location –
access from
adjacent cabinet
may be required
Allow
1” (2.5 cm)
minimum for
overlap of
oven top and
bottom
of cutout
18” (45.7 cm)
27” (68.6 cm)
Cutout Width
25” (63.5 cm)
Min.
25 1/4” (64.1 cm)
Max.