GE ZIC30GNDII - Manual (Page 17)

17
Installation Instructions
STEP 9 REVERSE DOOR SWING
(cont)
.
9. Install the screws on the fresh food compartment
cabinet in all 4 places. Screw them in about halfway.
STEP 9 REVERSE DOOR SWING
(If needed)
Skip this step if door swing is satisfactory.
1. Open the fresh food door.
WARNING:
THIS NEXT STEP IS
IMPORTANT FOR SAFE HANDLING OF AN
UNLOADED HINGE. DO NOT SKIP STEP 2.
2. Release the hinge springs by using a Torx T-20 wrench
to loosen the Torx screw from | to 0 on both hinges.
Close the door.
4. Open the hinges. Using a 5/32" Allen wrench, remove
the 2 screws per hinge that secure the hinge to the
refrigerator cabinet.
3. Using a 5/32" Allen wrench, remove the 2 screws per
hinge that secure the door to the refrigerator. Have
someone hold the door while removing these screws
to keep the door from falling.
8. The hinges will be reinstalled in opposite corners.
The hinge from the top will be turned over
and installed at the bottom of the fresh food
compartment. The hinge from the bottom will be
turned over and installed at the top of the fresh food
compartment.
10. To install the top hinge, turn the hinge in the proper
direction—the section of the bracket that will be
attached to the door should be at the bottom of the
hinge. Slide the hinge over the screws and seat the
tabs into the hinge pocket. Tighten the screws.
11. To install the bottom hinge, turn the hinge in the
proper direction—the section of the bracket that will
attach to the door should be at the top of the hinge.
Slide the hinge over the screws and seat the tabs
into the hinge pocket. Tighten the screws. Close
the hinge.
Screws
Screws
Top Hinge Bottom Hinge
Slots for
Tabs Screws
Screws
5. Remove the trim and hinge pocket from the top
of the refrigerator and install on the opposite sides.
6. Remove the trim and hinge pocket from the bottom
of the fresh food compartment. Remove the control panel
and gently place in the FZ drawer.
7. Reinstall the control panel.
12. Remove the hinge brackets from the door and reinstall
them on the opposite end, top and bottom.
Control Panel