GE ZIC30GNDII - Manual (Page 19)

19
Installation Instructions
STEP 12 INSTALL DOOR AND DRAWER
PANELS
1. Remove all door and drawer hooks from the unit and
screw them to the custom panels, aligning them with the
lowest set of predrilled holes for Monogram Panel Kits on
the FF door panel.
2. Attach top L-Bracket to FF panel.
3. If you had custom handles made and they are not
currently attached to your panels, do so now.
4. Open the fresh food door to attach the fresh food panel.
5. Slide the hooks on the fresh food panel into the slots of the
door, and lower the hooks into place. Make sure the
bracket on the top of the panel slides over the screw posts
on top of the door. The brackets will rest on top of the nuts.
6. Adjust the screw posts up or down under the bracket
on top of the door to level the panel.
7. Lock the panel to the door by installing the nuts
provided onto the screw posts on top of the door.
Next, screw the L-bracket provided into the bottom of
the door and the panel.
Hooks
Top of
Fresh Food
Panel Door
Nut
Nut
Slots
Bracket
Screw Post
STEP 12 INSTALL DOOR AND DRAWER
PANELS (cont).
7. Install the Freezer drawer panel by sliding the brackets
up into place (the opposite direction of the hooks on the
fresh food panel and Convertible drawer). .
8. Once the drawer panel is placed fasten the panel to the
drawer by screwing the bottom bracket into the panel
with the screws provided.
9. Repeat for the second drawer by sliding the hooks down
instead of up.
10. If using custom toekick attach the toekick panel by
placing Velcro on the back of the panel, and on the front
of the toekick. If using SS toekick it is magnetic.
11. Adjust drawer alignment using lower brackets as
needed to create uniform gaps.
Slots
Hooks
Screw Post
Bracket
Bracket
Back View of Panel Hooks and Bracket
Fresh
Food
Door
Convertible
drawer
Freezer
Drawer
Freezer
Drawer
The lower brackets on the Fresh Food & Convertible Drawer
should not be installed until after the panel is in place.
Hooks on the Freezer
drawer panel face up.