GE ZDT800SSFSS - Manual (Page 12)

STEP 18 CONNECT DRAIN LINE (Cont.)
• Connect drain line to air gap, waste tee or disposer using
the previously determined method. Secure hose with a
screw-type clamp.
Method 1 – Air gap with waste tee or disposer
0HWKRG²´+LJKGUDLQORRSµZLWKZDVWHWHHRUGLVSRVHU
With this method you will need the drain hose hanger set
aside in Step 1.
Fasten drain hose to underside of countertop with the pro-
vided hanger.
IMPORTANT –
When connecting drain line
to disposer, check to be sure that drain plug has been
removed. DISHWASHER WILL NOT DRAIN IF PLUG IS LEFT
IN PLACE.
Tip: Avoid unnecessary service call charges for a
no drain complaint.
Make sure excess drain hose has been pulled through
the cabinet opening. This will prevent excess hose in the
dishwasher cavity from becoming kinked or crushed by the
dishwasher.
STEP 19 CONNECT POWER SUPPLY
If a power cord with plug is already installed
proceed to Step 20.
In this step you will need the junction box cover and the #10
Hex head screw from the screws set aside in Step 1.
• Secure house wiring to the back of the junction box with a
strain relief.
• Locate the 3 dishwasher wires, (white, black and green)
with the stripped ends coming out of the AC jumper. Use
UL listed wire nuts of appropriate size to connect incoming
ground to green, white to white and black to black.
• Install the junction box cover using #10 hex head screw.
Check to be sure that wires are not pinched under the
cover.
• Make sure that the junction box cover is resting on the
mounting bracket.
• If using a Power Cord Kit, please refer to the included
instructions.
Dishwasher Installation
Waste Tee Installation Disposer Installation
Figure AB
Waste Tee Installation Disposer Installation
Figure AC
18"
Min.
32"
Min.
32"
Min.
18"
Min.
Drain Hose Hanger
Remove
Drain
Plug
WARNING:
If house wiring is not 2-wire with ground, a ground
must be provided by the installer. When house wiring
is aluminum, be sure to use UL-Listed anti-oxidant
compound and aluminum-to-copper connectors.
Figure AD
Ground
(Green)
NOTE: Do not remove the
Junction Box Bracket.
AC
Jumper
Junction Box
Bracket
Black
White
Ground Screws
12