GE ZDT800SSFSS - Manual (Page 3)

PARTS SUPPLIED IN INSTALLATION
PACKAGE:
• Junction box cover and #10 hex-head screw
• Hose clamp
• Drain hose (approximately 78” long)
• Drain hose hanger
• 2 #8-18 hex head screws to secure brackets to
washer tub frame
• 1 top trim piece
• 2 side trim pieces
• 2 mounting brackets for wood countertops
or side cabinets
• 2 #8-18 x 5/8” Phillips special head screws,
to secure dishwasher to underside of
countertop or to side cabinets
• Literature, samples and/or coupons
TOOLS YOU WILL NEED:
• Phillips-head screwdriver
• 5/16” and 1/4” nutdriver
• 6” Adjustable wrench
• Level
• Carpenter’s square
• Measuring tape
• Safety glasses
• Flashlight
• Bucket to catch water when flushing the line
• 15/16” socket (optional for skid removal)
• Gloves
• Pliers
For New Installations Only:
• Tubing cutter
• Drill and appropriate bits
• Hole saw set
MATERIALS YOU WILL NEED:
• 90° elbow (3/4”hose internal thread on one end,
opposite end sized to fit water supply)
• UL-listed wire nuts (3)
• Masking Tape
Materials For New Installations Only:
• Air gap for drain hose, if required
• Waste tee for house plumbing, if applicable
• Electrical cable or power cord depending on your
model, quick connect power cords are availble.
• Screw-type hose clamps
• Strain relief for electrical connection
• Hand shut-off valve (recommended)
• Hot Water Line–3/8” minimum, copper tubing
(including ferrule, compression nut) or GE Part #
WX28X326, flexible braided hose.
• GPF12 or WD24X10065 drain hose (12’ long), if needed.
Installation Preparation
3
Hole Saw Set
Measuring Tape
Tubing Cutter
Drill and Bits
Phillips-Head
Screwdriver
15/16” Socket
1/4” and 5/16”
Nutdriver
6” Adjustable
Wrench
Bucket
Flashlight
Gloves
Carpenter’s
Square
Safety Glasses
Level
'UDLQ+RVH
+RVH&ODPS
+H[+HDG0RXQWLQJ
Bracket Screws
'UDLQ+RVH+DQJHU
Junction
%R[&RYHU
#10
+H[+HDG
Junction
%R[6FUHZ
1/2" long
Mounting
Brackets
#8 Phillips
Special
+HDG6FUHZV
5/8" long
Literature
Top Trim Piece
Side Trim Pieces
+RW:DWHU/LQH
Strain Relief
Optional

'UDLQ+RVH
GPF12 or
WD24X10065
+RVH&ODPSV
Waste Tee
Electrical Cable
(or Power Cord, if applicable)
Wire Nuts (3)
90°Elbow
Masking Tape
(if applicable)
+DQG
6KXW2ȹ
Valve
Air Gap
Pliers