GE 45146 GE Choice Alert Wireless Keypad - Manual (Page 10)

10 11
Mounting the Wireless Keypad onto a Wall (using
double sided tape strips)
Select a suitable location that provides protected, easy
access. Be sure to test the device before mounting.
Clean both surfaces with 50/50 mix of isopropyl
alcohol and water. Using the provided double sided
tape strips, peel one side and firmly apply to the
indented areas on the back of the mounting plate.
Peel the remaining side of the double sided tape and
lightly mount to the wall. Once you are confident with
the placement, press firmly to secure to the wall.
Mounting the Wireless Keypad onto a Wall (using
screws/wall anchors) – you will need a drill, 3/16” or
1/8” drill bit and screwdriver.
Step 1. Remove the top cover from the mounting
plate. (See Removing the Top Cover from the
Mounting Plate.) Set the top cover aside.
Step 2. Select a suitable location that provides
protected, easy access. Be sure to test the device
before mounting. Use the mounting plate as a
template. Be sure to position the mounting plate with
the arrow pointing up. Mark the two holes on the wall
for the anchors and/or screws as shown. Please be
sure to mark the center of the holes.