GE 45146 GE Choice Alert Wireless Keypad - Manual (Page 9)

8 9
Step 1. Press and release Green button. Enter Current
Master code. Press and release the Green button. The
LED will light.
Note: You have approx 30 seconds to make a selection
at each step, or the LED will flash 3 times and turn off.
If it does, you’ll have to start over.
Step 2. Enter a number (2, or 3) for the code you
would like to erase (2= User 2 code, 3 = User 3 code).
Press and release the Green button three times.
The LED will flash 5 times and turn off indicating the
code for that number has been erased.
Placement of the Wireless Keypad.
The Wireless Keypad is designed to be mounted inside
onto a wall, or it can lay on a flat surface (such as a
night stand). If mounting to a wall, use the double-
sided tape strips or the screws/wall anchors (both
included).
Note (1): Do not mount in an exterior location; the
Wireless Keypad is not weather resistant.
Note (2): The Wireless Keypad can transmit up to
150ft. However like all wireless devices, this distance
is subject to conditions of the home. The number of
walls and appliances between the Wireless Keypad
and the location of the Control Center can reduce
the signal transmission distance. When selecting a
placement, test the Wireless Keypad at the location
before mounting. Using a signal repeater can extend
the transmission distance.