JELD-WEN JII020 Premium Aluminum (A-500) and Premium Atlantic Aluminum Sliding Patio Doors - Manual (Page 7)

ASSEMBLY AND INSTALLATION INSTRUCTIONS
for Premium Aluminum (A-500) and Premium Atlantic Aluminum Sliding Patio Doors (JII020)
7
PG20 ONLY - SECURE STATIONARY PANEL(S)
1. Working from the
inside, slide the
stationary panel into
the jamb pocket.
2. For PG 20 units only:
From the interior,
pre-drill holes 3"- 4"
from each corner
and one at center.
Secure with 3 screws
through the jamb
into the panel frame
using the provided
#8 x 3/4" screws.
Seal screw points
with polyurethane
or 100% silicone
sealant.
DP 50/65/80 ONLY - SECURE STATIONARY PANEL(S)
On units with a
stationary panel in
the exterior track, the
fixed “O” panel will
need to be secured as
follows.
1. Working from the
inside, slide the
stationary panel
into the jamb
pocket.
2. For DP 50/65/80
units, secure using
offset T clips located
at the head and sill,
6" from the jamb as
shown. DP80 units
have additional
clips that must be
installed in the
same positions on
the exterior. First,
position the clip
with the short leg
under the panel.
Pre-drill through
the clip and frame,
coat the screw threads with sealant, and then screw the clips into the
head and sill of the door frame. Then, secure the other end of each
clip through the pre-drilled holes to the interior side of the panel;
seal screw points with polyurethane or 100% silicone sealant.
INSTALL PANELS - CONTINUED
6
INSTALL EXTERIOR PANEL(S)
1. Insert exterior
panels, making sure
the panel interlock
is facing the
interior.
2. Place the slot of the
panel head over the
middle guide leg of
the frame head.
3. Raise the panel and
swing the bottom
in so the wheels are
properly located
over the track.
ADJUST ROLLERS
Lift each panel and
adjust the rollers
with a #2 Phillips
head screwdriver by
turning the bottom
screw on the ends of
both panels. Do not
use a power driver. All
door panels, including
stationary panels,
have wheels that need
to be adjusted. Adjust
door to ensure jambs,
interlocks and grid patterns line up.
Note! Turn clockwise to raise the panel, counterclockwise to lower
the panel.
Bumper(s) must be installed 6" from each jamb in the head track behind
operating panel(s). Secure in place using frame installation screws to
anchor into the building structure.
An additional bumper must be installed on the secondary operating
panel of any set of stacking panels.
6"
Bumper(s)
Fixed
panel
Primary
operating
panel
Secondary
operating
panel
Screw
PG 20 Door (Interior)
Screw
Center
3"- 4"
3"- 4"
Clip
Clip
DP 50/65/80 Door (Interior)