Audiovox ACD-32A - Manual (Page 17)

128-5272
17 of 20
16 16 16 16 16
SPECIFICATIONSSPECIFICATIONSSPECIFICATIONSSPECIFICATIONSSPECIFICATIONS
SPECIFICATIONS SPECIFICATIONS SPECIFICATIONS SPECIFICATIONS SPECIFICATIONS
7" W x 2" H x 6-1/4" D
178 mm x 50 mm x 160 mm
12 volts DC, negative ground
64 watts maximum
Floating-ground type designed for 2 speaker use.
May also be used with 4 speakers.
RCA low-level outputs.
Compatible with 4-8 ohm speakers.
500 mv.
AM: 530-1,720 KHz. (10 KHz. step)
522-1,620 KHz. ( 9 KHz. step)
FM: 87.5-107.9 MHz. (200 KHz. step)
87.5-108.0 MHz. (50 KHz. step)
AM: 20 uv.
FM: 1.5 uv.
30 dB
20-20,000 Hz. ± 2dB
>70 dB
>60 dB
>80 dB
<0.1% T.H.D.
Size:
Operating Voltage:
Output Power:
Output Wiring:
Output Impedance:
Low-Level Output:
Tuning Range:
Sensitivity:
FM Stereo Separation:
CD Frequency Response:
CD Signal/Noise Ratio:
CD Channel Separation:
CD Dynamic Range:
CD Distortion:
*Specifications are subject to change without notice.
FREQUENCY STEP SWITCH FREQUENCY STEP SWITCH FREQUENCY STEP SWITCH FREQUENCY STEP SWITCH FREQUENCY STEP SWITCH
This unit is supplied pre-set at the factory for reception of North American radio
stations (10 KHz. channel spacing on AM/200 KHz. spacing on FM). Use in other
areas in the world may require different channel spacing. A switch on the bottom of
the chassis allows selection of 9 KHz. AM/50 KHz. FM channel spacing. Slide the
switch to the appropriate position using a small screwdriver blade. The Re-Set button
dm
on the front of the chassis must then be pressed to activate the change of channel
spacing.