Audiovox ACD-32A User Manual

Page 18

Advertising
background image

128-5272

18 of 20

17

17

17

17

17

TROUBLESHOOTING

TROUBLESHOOTING

TROUBLESHOOTING

TROUBLESHOOTING

TROUBLESHOOTING

TROUBLESHOOTINGTROUBLESHOOTINGTROUBLESHOOTINGTROUBLESHOOTINGTROUBLESHOOTING

PROBLEM

PROBABLE CAUSE

CHECK FOLLOWING

Unit completely inoperative no
lights, no sound

Unit will not keep time or radio
station memory

Noise on both radio and CD

Noise on radio only

Poor FM reception and almost no
AM reception

No sound on one speaker
(both radio and CD)

Poor sound-new unit

CD sound skips

Incorrect power connection

Blown fuse

Incorrect power connection

Blown fuse

Poor ground

Dirty or corroded battery posts

If problem also existed with pre-
vious radio you removed

Antenna

Antenna

Wiring

Speaker

Control Settings

Speakers or speaker wiring

Installation angle is greater than
20°
Disc player is not installed cor-
rectly

Dirty, scratched, or defective disc

Condensation on laser lens

Orange/White stripe wire to +12V ACC.
and Green/White stripe wire to +12V
battery

Check fuses in wires listed above and
check car fuse block

Green/White stripe wire is not connected
to a "live" +12V battery source

Check fuse in Green/White stripe wire
and at car's fuse block

Check Black/White stripe wire for proper
grounding

Clean and tighten connection

Consult your local garage mechanic-car
may need tune-up or noise filter

Check that antenna base is grounded.
Test with antenna disconnected. If noise
goes away, replace antenna

Replace antenna and antenna cable

Check speaker wiring

Test with good speaker

Check balance and fader controls

Check rating of speakers for sufficient
power capacity
Check that speakers are in good
condition
Check that none of the speaker wires are
grounded

Check speaker wiring

Adjust the mounting angle to less than
20°
Make sure disc player is mounted se-
curely
Clean disc if dirty; replace if badly
scratched or defective

Allow condensation to dry, then try again

Advertising