Audiovox ACD-32A User Manual

Page 7

Advertising

128-5272
7 of 20

INSTALLRADIOUSINGSAME
PROCEDUREASEXPLAINED
ONPAGES3AND4

SUB-DASHBOARD
(RADIOAREA)

MOUNTINGPLATEFROMKIT
(NOTINCLUDEDWITHRADIO)

FACTORYDASHPANEL

MOUNTINGSLEEVE

RADIO

DETACHABLEFRONTPANEL

REMOVALTOOLS

IMPORTANT

AMOUNTINGKITISREQUIRED

FORTHISINSTALLATION

CHEVROLET-OLDSMOBILE-BUICK-PONTIAC-GMC-CADILLAC-SATURN INSTALLATION

CHEVROLET-OLDSMOBILE-BUICK-PONTIAC-GMC-CADILLAC-SATURN INSTALLATION
AllU.S.MadeCars,Trucks,andVansBuiltSince1982

AllU.S.MadeCars,Trucks,andVansBuiltSince1982

Important-This radio cannot be installed in any "GM" vehicle without an installation kit. Refer to Kit Listings
on page 2 for the required kit. Complete kit installation is explained in the instructions included with kit. This
radio cannot be installed in GM vehicles built before 1982.
CAUTION:

1. DO NOT CUT OR FILE THE OPENING TO THE OUTER EDGES OF THE TEMPLATE!
2. FOR PROPER OPERATION OF THE CD PLAYER, THE CHASSIS MUST BE WITHIN 20° OF

HORIZONTAL. MAKE SURE THE UNIT IS MOUNTED WITHIN THIS LIMITATION.

1. RemoveExistingRadio:

A. Remove existing radio dash trim panel surrounding the radio opening. This panel is usually secured

by screws and/or snap-in clips.

B. Remove the screws used to secure radio to the sub-dashboard.

Helpful Hint: If you do not have an existing radio, you will find the radio opening is covered by a

disposable cover plate.

C. Pull the radio forward to access the wiring and antenna cables plugged into the rear of the chassis.
D. Un-plug the wiring harness(es) and antenna cable and remove the radio.

2.InstalltheNewRadio:

A. Following the instructions included with the installation kit, secure the sleeve from the radio to the

mounting plate from the kit as explained on page 3.

B. Install the sleeve/mounting plate assembly to the sub-dashboard as per the instructions with the

installation kit.

C. Replace the dashboard trimpanel.
D. Following the instructions of steps 4 and 5 on page 4, carefully wire the radio and complete installation

into the mounting sleeve.