Rocky Mountain Radar RMR-8RDS - Manual (Page 3)

COMPONENTS
Your RMR-8RDS remote consists of the following components:
(1) Control module
(1) Velcro Tape for control module
(1) Front Antenna for Radar and Laser detection
(1) Mounting Bracket for Front Antenna
(1) Dual Lock Tape for Front Antenna
(2) Special Screw for installation of the bracket with antenna
(10) Washer Screws for mounting the bracket
(10) Cable Tie
(1) Coiled 12V DC Power cord
(2) Scrambler modules with Laser detection (identical)
(2) Dual Lock Tape for scrambler modules
(1) Owners Manual
(1) Ticket Registration Booklet
Before installation do a preliminary layout of the modules
and cables for proper fit and length of cables.
INSTALLATION
Complete, sign, and mail Ticket Rebate Registration card.
NOTE: It is very important that the power on the Control
Panel is not on while you plug and unplug the modules.
Front Antenna
It is very important that the front antenna is mounted properly.
Determine the best location for the front antenna. The optimal
location for mounting the front antenna depends on the
vehicle’s type. In most vehicles the best mounting location is
directly behind the grill through the slot openings. It should
have a clear view of the road ahead. Other locations that
provide concealment and/or protection of the antenna may be
acceptable.
Using the supplied mounting bracket, mark location and drill
pilot holes in the vehicle if necessary.
Fit the mounting bracket using the washer screws.
Verify the lens of the front antenna has a clear view of the road
ahead.
You can use the included Dual Lock tape to attach the mounting
bracket. Thoroughly clean any surface before the tape is
applied.
Front Scrambler
It is very important that the scrambler is mounted properly. The
scrambler scrambles the radar and laser signals received from
the front and detect laser signals.
Determine the best location for the scrambler. For optimum
performance, install the scrambler on either side of the front
license plate on the bumper or in the front grill area.
Using the built in mounting bracket, mark location and drill
pilot holes in the vehicle if necessary.
3
NOTE:
DO NOT drill holes in the front antenna or scrambler modules.