Rocky Mountain Radar RMR-8RDS - Manual (Page 4)

Thoroughly investigate the location before drilling any holes.
Keep all cables away from moving parts and hot surfaces
(Radiator, hoses, engine, etc.)
Make certain that the modules are level and have a clear view of
the road ahead.
Rear Scrambler
The rear scrambler detects and scrambles the laser signals
received from the rear and scrambles all radar.
Determine the best location for the rear scrambler. For optimum
performance, install the rear scrambler on either side of the rear
license plate or above third brake light on the rear deck.
Control Module
Determine the best location for the control module in the
vehicles interior.
Install the control module using the supplied Velcro tape.
4
NOTE: It is very important that the power on the Control
Panel is not on while you plug and unplug the modules.
Route cable and plug into jack.
The front antenna cable plugs into the front jack on the Control
module.
The scrambler cable from the front plugs into “AUX” jack on
the Control module.
The scrambler from the rear goes into the rear jack on the
Control module.
NOTE: Verify the Control module is clearly visible from the
drivers position and that the controls can be easily accessed
without interfering with normal driving.
FRONT ANTENNA
REAR SCRAMBLER/
LASER DETECTOR
FRONT SCRAMBLER
AUX
DC 12V
NOTE: It is very important that the power on the Control
Panel is not on while you plug and unplug the modules.
Front Antenna Cable
Route front antenna cable and secure with supplied cable ties.