Rocky Mountain Radar RMR-C495 - Manual (Page 3)

Mounting the RMR-C495 to your windshield:
1) Attach the windshield bracket to the RMR-C495
unit. Align the edge on the bracket with the slot
opening on the front of the case. Slide the bracket
gently into the case until it locks into place. Make
sure not to twist the bracket while inserting.
2) Place the windshield bracket in the upper center
portion of the windshield. The ideal position will be
right below the rearview mirror. Press suction cups
firmly against windshield to adhere suction cups.
Note: Place away from wipers or other objects
that might interfere with performance of the unit.
Tinted glass will degrade the laser performance.
3) Bend the windshield mount bracket so the unit is
in a level position.
4) The RMR-C495 will hang from the bottom of
the bracket and must have an unobstructed view of
the road ahead.
5) Insert the small end of the power cord gently into
the power jack on the left side of the unit and the
large end into the cigarette lighter receptacle.
Remote-mounting is not recommended.
Hard wire: Remove cigarette lighter plug. Connect
the red wire to +12 Volts, and connect the white
wire to ground.
This product has been designed and certified to
comply with Part 15 of the FCC Rules. Any
changes or modifications not expressly approved
by Rocky Mountain Radar may void your
authority to use this product. Operation is subject
to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device
must accept any interference received, including
interference that may cause undesired operation.
2