Rocky Mountain Radar RMR-C495 - Manual (Page 4)

CONTROLS: There are 3 buttons on top of the
RMR-C495: Dim/Menu, Mute/Select and City.
Dim: To adjust brightness press the Dim button for
a split second (momentary contact) to select
between Bright, Dim, Dimmer, and Dark. To
brighten the alarm lights press the Dim Button
again until you reach desired setting. In Dark mode
there will be a “P” light on. If a signal is present
there will be no visual band alert only a sound alert.
Note: If the unit is in Dark mode the Mute mode
cannot be engaged.
Menu: Press and hold the Menu button down for
an extended period of time (approximately 3 to 5
seconds) to go into Menu mode. When Menu mode
is displayed press and release in step increments
then press Select button to change the setting. The
menu items are: Voice on/off, English/Spanish
voice, High/Low tone, Test on/off, All Reset. If All
Reset is selected Cleared is displayed and all
settings go to factory default. If no button is pressed
after 5 seconds of being on Menu mode the current
settings are stored and exits automatically the word
Exit is displayed. During the start up sequence the
current menu settings are displayed. The factory
settings are: Bright, Highway, Mute off, Voice on,
English voice, High tone, Scrambler on, Test on.
Mute: Press the Mute button for a split second
(momentary contact) to select “Mute On”, “Auto
Mute”, or “Mute Off”, Mute On mode disables
voice and beeping sounds for quiet operation. Auto
Mute mode will alarm 4 times then go into mute
mode, but the display will keep blinking.
City: Engage the City function to reduce false
alarms in high RF noise areas. City function
reduces the K-Ka sensitivity by 50%. Highway
mode has all bands at 100% sensitivity.
Reminder: If you forget the settings you last used
on the unit use the ALL Reset mode to set the unit
back to factory default.
3