Rocky Mountain Radar RMR-C495 - Manual (Page 5)

Reminder! The C495 will memorize the settings
of the features above when the unit is powered
off. Be sure to re-adjust the settings to your
normal preferences.
Tutorial Mode: To run the system diagnostics
check on the unit press and hold down both the
Mute and City buttons simultaneously for an
extended period of time (approximately 3 to 5
seconds). The unit will perform a test sequence to
verify all systems are operating properly. The unit
will automatically reset back to operation mode
once the tutorial is completed.
Power and Volume: Power is provided through
the thumb wheel switch on the left side of the unit.
Rotate the wheel forward to turn on and increase
the volume for the alarm.
Caution!
Note: To prevent possible heat damage or theft, do
not leave unit in direct sunlight or plain sight when
not in use
Alarms: A separate alert tone will sound for each
band of Radar encountered with frequency band
displayed K, Ka, or LASER. The signal strength
indicators are 5 arrows, the stronger the signal the
more arrows will display. Tone frequency will
increase as signal strength becomes stronger.
Signal Strength: Signal Strength will be first
indicated by the illumination of the LED of the
band detected, then followed by 1 thru 5 arrows.
When all 5 arrows are illuminated the signal is
strongest.
VG-2: 100% undetectable.
4