SIGMA ROX 6.0 CAD - Manual (Page 26)

ROX 6.0
www.sigmasport.com roX 6.0 Page 26
Display backlight
General roX 6.0 functions
5 General ROX 6.0 functions
5.1 Display backlight
The backlight function is switched on/off by simultaneously pressing the Set
and
Reset
buttons. “Light on/Light off” briefly appears on the display.
The display lights up when any button is pressed; the respective function only
opens when the button is pressed a second time.
Note
The backlight is not available during synchronization! Avoid using the backlight
unnecessarily to conserve the battery.
5.2 Speed comparison
If the current speed differs from the average speed, this difference is shown by
either of two arrows
.
If the current speed is below the average speed, is displayed.
If the current speed is above the average speed, is displayed.
If the current speed is more or less equivalent to the average speed,
no arrow is displayed.
5.3 Lap counter
you can use the lap counter to record laps (or intervals) after covering a certain
distance or time. This enables you to compare your performance throughout
interval training.
Press the middle button ( LAP ) to end the current lap and automatically start a
new one. The lap distance and lap time of the last lap are alternately displayed for
eight seconds.
The lap distance and lap time are displayed in the bottom display segment.
The average heart rate, average cadence, and lap number are shown in the top
display segment. The average speed for the last lap is shown in the middle display
segment.
The display then jumps back to the previous view mode.
Reset
Set
Lap