Alto-Shaam Cook & Hold Oven Electronic Control 1000-TH/III - Manual (Page 22)

pg . 20 TH/III InsTallaTIon / operaTIon / servIce manual
O p E R A T I O N
programming a preset
Select the product to be programmed and begin programming with the oven control power O ff .
press and release control O
n
/O
ff
key. The oven will beep for one second and power to the unit
will be indicated by an illuminated green indicator light located in the upper left corner of the
O
N
/O
ff
key. The oven will begin operating in the hold mode. The amber H
old
indicator will be
illuminated and the last set hold temperature will be displayed.
To set Cook temperature — Press c
ook
Key. Oven preheat indicator will illuminate and the last
set cooking temperature is displayed. To change the cook temperature, press the u
p
or d
own
a
rrow
Keys.
if cooking by time — press the t ime
Key. The green t
ime
indicator will illuminate and the last set
cooking time will be displayed. To change the set time, press the u
p
or d
own
a
rrow
Key. The
display will alternate between the set temperature and the elapsed time.
if cooking by probe — press the p
robe
Key. The green p
robe
indicator will illuminate and the last
set internal product temperature will be displayed. To change the set temperature, press the u p
or d
own
a
rrow
Key. The display will alternate between the set temperature, the elapsed time,
and the probe temperature.
To set Hold temperature — Press the h old
Key. The green cook indicator light will remain
illuminated. To change the hold temperature, press the u
p
or d
own
a
rrow
Key. The display
will alternate between the set hold temperature and the amount of time the product has been in
the hold mode. Oven will remain in the h
old
mode until the o
N
/o
ff
key is pressed.
Select a letter code for the product programmed by the previous steps. Press and hold the selected
p
reset
key for two seconds. When the preset has been saved, you will hear a one second beep and the
preset light will illuminate.
note: Only one preset can be programmed at a time. If programming an additional preset is
desired, the unit must be started and stopped either by cycling the power to the cavity or by
pressing the S
tart
/S
top
key. The last p
reset
Key used will be the oven cooking run sequence
for the next product to be programmed. Settings can be manually changed for the next
product and an alternate pre-programmed letter key selected.
Erasing a preset
To erase a program, the oven must be in either the power-up hold mode or in the preheat mode. The oven
cannot be running a p
reset
Menu program.
When the oven is in the power-up hold mode or in the preheat mode, press and hold the c
ancel
Key and
then the appropriate letter p
reset
Key to be erased for two seconds. When the preset has been erased the
oven will beep for one second.
important -
after programming a specific product into memory in a programmable
preset key, it is very important to make a written permanent record of the product and the
program letter assigned. menu card (pE-23384) is provided for this purpose.