Sper Scientific 850023 Anemometer SD Card Logger - Manual (Page 13)

13
SETUP MODE
2. Press ▲ or ▼ to select Basic (.) or Euro (,). Press
ENTER to save the selection.
Auto Power Off
The meter automatically turns off after 10 minutes of
inactivity, however this function can be disabled.
1. Enter the auto power off function from Setup Mode (see
page 11). “PoFF” appears on the LCD.
2. Press ▲ or ▼ to select yes (auto power off enabled) or
no (auto power off disabled). Press ENTER to save the
selection.
Touch-Tone
1. Enter the touch-tone function from Setup Mode (see
page 11). “bEEP” appears on the LCD.
2. Press ▲ or ▼ to select yes (touch-tone enabled) or no
(touch-tone disabled). Press ENTER to save the
selection.
Thermometer Type K/J
1. Enter the thermometer type function from Setup Mode
(see page 11). “tYPE” appears on the LCD.
2. Press ▲ or ▼ to select K or J. Press ENTER to save
the selection.
Temperature Units
1. Enter the temperature units function from Setup Mode