Sper Scientific 850023 Anemometer SD Card Logger - Manual (Page 14)

14
SETUP MODE
(see page 11). “t-CF” appears on the LCD.
2. Press ▲ or ▼ to select C (degrees Celcius) or F
(degrees Farhenheit). Press ENTER to save the
selection.
Sampling Time
The sampling time is the time allotted between successive
measurements. To adjust the sampling time (in seconds):
1. Enter the sampling time function from Setup Mode (see
page 11). “SP-t” appears on the LCD.
2. Press ▲ or ▼ to adjust the value (0, 1, 2, 5, 10, 30, 60,
120, 300, 600, 800, 1800, 3600 seconds). Press
ENTER to save the value.
SD Memory Card Format
Enabling this function will format the SD memory card to
work specifically with your meter. Formatting the SD card
will erase any previous memory on the card. New SD cards
should be formatted to work with your meter.
1. Enter the SD memory card format function from Setup
Mode (see page 11). “Sd F” appears on the LCD.
2. Press ▲ or ▼ to select yes (format the SD memory
card) or no (do not format the SD memory card). Press
ENTER to confirm your selection. If selecting yes, “YES
Enter” will appear on the LCD, press ENTER again and
the meter will format the SD card.