Sper Scientific 850057K AquaShock pH Kit - Manual (Page 10)

10 11
Restore Factory Settings
1. Press SETUP to enter the Setup Mode.
2. Press ↑ or ↓ to select the Restore Factory Settings screen.
3. Press SETUP to confirm selection. “NO” will flash on the LCD.
4. Press ↑ or ↓ to select “YES” or “NO.”
5. When “YES” is displayed, press SETUP to confirm and all
parameters will restore to factory settings (except the clock)
and the meter returns to Normal Mode.
6. Press EXIT to return to Normal Mode without saving.
View Calibration Data
1. Press SETUP to enter the Setup Mode.
2. Press ↑ or ↓ to select the View CAL Data screen.
3. Press SETUP to enter the mode.
4. Press ↓ to view the previous calibration point. Press ↑ to
view the next calibration point. The date and time is on
cyclical display.
5. Press EXIT to return to Normal Mode.
View Probe Parameters
1. Press SETUP to enter
the Setup Mode.
2. Press ↑ or ↓ to select the View
Probe Parameters screen.
Note...
If the meter is not calibrated, the screen will show:
Press SETUP or EXIT to
return to Normal Mode.