Sper Scientific 850057K AquaShock pH Kit - Manual (Page 9)

9
SETUP MODE
The Setup Mode allows you to customize the following
meter preferences and defaults:
• Temperature Units
• Clock Setting
• Restore Factory Defaults
• View Calibration Data
• View Probe Parameters
1. Press POWER for 1 second to turn the meter on before
performing any setup function.
Temperature Units
1. Press SETUP to enter the Setup Mode.
2. Press SETUP to enter the Set Temperature screen.
3. The unit °C or °F will flash on the LCD.
4. Press ↑ or ↓ to select the °C or °F temperature unit.
5. Press SETUP to save and return to Normal Mode.
6. Press EXIT to return to Normal Mode without saving the selection.
Real Time Clock
1. Press SETUP to enter the Setup Mode.
2. Press ↑ or ↓ to select the Set Clock screen.
3. Press SETUP to set the year. The value will flash on the LCD.
4. Press ↑ to increase the value by 1. Hold down ↑
to continually increase the value.
Press
↓ to decrease the value by 1. Hold down ↓
to continually decrease the value.
Press
SETUP to save and the meter automatically
moves to the month setting.
5. Repeat step 4 to adjust the month, day, hour, and minute.
6. Press EXIT to return to Normal Mode without saving.
Note...
This procedure adjusts the meter’s internal clock. The internal
clock will function when the meter is turned off but only when the
battery is installed.