Yetter Avenger 30 Coulter - Manual (Page 11)

11
OPTIONAL EQUIPMENT
STEP 13. Assembly of 2986-108 Skid Shoe Kit.
The Skid Shoe can be attached to both R.H. and L.H. coulter assemblies. Begin by removing (2) ½” x 2”
bolts from the 2986-423 spring stop and save for the next step. Remove the bolts from the R.H. side
when working on a R.H. coulter or the bolts from the L.H. side when working on a L.H. coulter. Attach the
2986-327 to the spring stop using (2) ½” x 2” hex head bolts and reusing the locknuts that were saved
from the previous step. Next, attach the grease zerk 2533-110 to the arm 2986-209 and also insert
bushing 2986-422 (pre-lube bushing before installing) and attach to the 30” Coulter assembly using (1)
5/8” x 11” hex head bolt, (2) 5/8” flat washers and 5/8” hex lock nut. Attach the chain to the lower hole in
the arm using (1) ½” x 1 ½” hex head bolt, ½” flat washer and ½” hex lock nut. Hook the 6000-525 spring
to the chain link and hook the other end into 2986-326 Spring Adjust Lever. Attach the adjustment lever to
Lever Mounting Plate first using a ½” x 2 ½” hex head bolt, 2986-324 bushing and ½” hex lock nut in the
lower hole and using a ½” x 2 ½” bolt, tube spacer and ½” lock nut in the upper hole. Now attach the Skid
Shoe adjustment plate 2986-337 to the Skid Shoe Assembly 2987-107 using (1) 5/8” x 4” hex head bolt,
(2) 5/8” flat washers, ¾” spacer and (1) 5/8” hex lock nut. Fasten the Skid Shoe Assembly to the arm
2986-209 using (1) 5/8” x 3 ½” hex head bolt, (2) 5/8” flat washers and (1) 5/8” hex lock jam nut.
Adjust. Set the shoe to the blade, equally front and back. Start with no gap between the blade and shoe.
Set the shoe just touching the blade.