Yetter Avenger 30 Coulter - Manual (Page 4)

4
GENERAL INFORMATION
Examine all equipment carefully for damage or shortages.
2986-030 - 30” Avenger Coulter
includes QTY
(1) 2986-106 – Arm Assembly
(1) 2986-130 – Parts Box
(1) 2571-205 – 30” Blade
(1) 6000-002 – Close wheel Kit
Optional Equipment: 2986-108 – Skid Shoe Kit.
Lubricate all bearings and moving parts as you assemble and see that they work freely.
NOTE: When you are behind the coulter looking forward, the right hand coulter is assembled with the blade to
the right hand of the arm assembly. The left hand coulter is assembled with the blade to the left hand of the
arm assembly.
BOLT TORQUE
READ THESE INSTRUCTIONS FIRST:
1. Improperly tightened bolts will result in damage, breakage, expense, and down time.
2. Always replace bolts with the specified grade and type.
3. Torque properly before first use of the machine and every 2-4 hours of use until you are sure bolts
are staying tight.
4. The chart below is a guide for proper torque. Use it unless a specified torque is called out
elsewhere in the manual.
5. Torque is the force you apply to the wrench handle or the cheater bar, times the length of the handle
or bar.
6. Use a torque wrench whenever possible.
The following table shows torque in ft. lbs.