Yetter 71 Series Planter - Manual (Page 6)

6
ASSEMBLY INSTRUCTIONS
Step 1. Place the toolbar on two assembly stands approximately 28 inches above the floor or ground.
FRONT VIEW OF HITCH ASSEMBLY
Step 2. Bolt the center mast brackets (A) together using the 1” x 4-1/2” bolt, upper hitch pipe, lock washer and hex nut
(B). Also, attach the 6010-303 hitch pin in the lower hole of the upper hitch plates with ¼ x 2 roll pin and 1/8” hairpin
cotter.
Step 3. Bolt the 4) mount straps (C) to the center hitch assembly using 4) ¾” x 2” bolts, lock washers and hex nuts (D).
Step 4. Bolt the lower left hitch plate (E) to the end of the mount straps (C) and through the lower hole of the right hand
support bracket (H) using the ¾” x 2-1/2” bolts, lock washers and hex nuts (F).
Step 5. Bolt the lower right hitch plate (G) to the end of the mount straps (C) and through the lower hole of the right
hand support bracket (I) using the ¾” x 2-1/2” bolts, lock washers and hex nuts (F).
Step 6. Bolt the 7/8” lift pins (J) through the lower hitch plates and attach using the 6010-302 bushing and the lock
washer and hex nut included with the lift pins.
Step 7. Bolt both the support brackets (H) & (I) to the toolbar using the 5/8-11 x 4 x 5-1/2 u-bolts (K), lock washers and
hex nuts.
LEFT HAND TOP VIEW OF HITCH ASSEMBLY RIGHT HAND VIEW OF HITCH ASSEMBLY
A
B
C
D F
E
G
I
G
D
H
K
J
A
H
E
K