Yetter 6300 Coulter Cart - Manual (Page 5)

5
ASSEMBLY INSTRUCTIONS
WARNING:
Never work under the equipment while in a raised position without using
safety lockups. Failure to do so may lead to personal injury.
Transport Wheels
STEP 1. The carts are shipped with only the inside wheels assembled. Attach the outside wheel and hub
assemblies 6600-146 by inserting the spindle shaft into the tube welded to the bottom of the lift wheel insert
using 1) ½” x 3” hex bolt and ½” hex lock nut.
STEP 2. Check the air pressure in the four tires; the pressure must be EQUAL to each other (36 psi cold).
If the tire air pressures are not equal when operated, the upper and lower rollers will wear and fail to
operate, causing damage to the lift wheel insert.